Illuminated LED system. 8-circuit illumination LED system that can be controlled by remote control for plastic models, dioramas, mini cars, etc. I want to make the headlights and turn signals of my car model shine! But I can't do electronic work! In such a case, if you have this, you can easily illuminate it. What's more, using an infrared remote control, you can control the lighting and blinking from a distance. The LED is an extremely small chip LED measuring 1.6mm x 0.8mm, so it can be incorporated into very small places.Of course, the wiring is already soldered, so it can be easily incorporated into the model. Two LEDs are lit in one circuit, and there are 8-circuit, 6-circuit, and 4-circuit models available. All circuits can be turned on or blinking all the time, and in the case of blinking, the blinking speed can also be changed. In addition, it is possible to individually change the lighting time and extinguishing time when flashing, so it is possible to flash flashes such as flashing brightly and then turning off for a while. Furthermore, the brightness can be adjusted individually, so you don't have to worry about it being too bright and ruining the atmosphere. The width of the main body size is 37 mm for 8 circuits, 31 mm for 6 circuits, 26 mm for 4 circuits, and the height is 13 mm. Since the battery is one CR2032, it can be installed inside even 1/32 scale car models. There are models that use connectors for cable connection, and models that do not use connectors and require the purchaser to solder to the board. Models that require soldering are time-consuming, but the price is reasonable. For both models with and without connectors, you don't have to worry about ICs and small parts being already soldered. System contents controller body remote control receiver switch battery holder Button battery (for main unit and remote control) remote control 16 pre-wired LEDs (8-circuit model), 12 (6-circuit model), 8 (4-circuit model).