Application for: For motorhomes, campervans, caravans (also known as travel trailers and camper trailers), fifth-wheel trailers, popup campers and truck campers, Small Truck, Big Truck, Light Truck, Heavy Truck, Pickup, Van,Bus,Car,SUV, Boat, Forklift, Electric Tricycle, Engineering Vehicle, Yacht Packag included: 1 x Parking Heater with Four Holes 1 x LCD Switch 1 x Remote Controller (Batteries NOT included) 1 x Air Outlet Pipe 1 x Intake Pipe 1 x Exhaust Pipe 1 x Fixture Accessories Set as picture shows Specifications: Heater Power: 5KW Fuel Gasoline: diesel Car Air Conditioning Type: Heating Rated Voltage:12V Fuel Consumption(L/h): 0.1~0.24L Working Temperature of the Heater:-40?~+80? Heater Color: Red & Black Material: Metal & Plastic Features: -Smooth, automatic room temperature control with temperature pre-set facility. -Low fuel and power consumption, suitable for longer periods of operation. -More comfort through wide control range, quiet night-time operation. -Fully electronic microprocessor control. -Continuous monitoring. -Diagnostic system. -Power stage to cut heating times. -Low noise operation, most of the noise get reduced when it works. -Low maintenance, easy to service. -Can be operated whilst on the move. -Fuel supplied from the vehicle's own tank (diesel only). -Small and compact design for easy and space-saving installation within the interior or even under the floor -Independent heating device: Blow out warm air independently without causing wear and tear or carbon deposits in the engine, which can extend engine life by 30%. -Keep constant temperature: the intelligent overheating sensor can prevent the heater from running dry. -Can eliminate the window frost. -Environmentally product, low emissions, low fuel consumption; heater exhaust emissions to meet euro IV engine emissions requirements. -Can dismantle to a new car when replace vehicle. -Volatile technology, by the ceramic ignition plug will fuel heating evaporated into gas, fast ignition, full combustion. Important Installation Note: 1. The fixed backboard should be sealed and separated from vechicle sheet metal during installtion to avoid physical injury to the driver when the combustion gas flows in the driving cab from the gap. 2. The exhaust pipe length shall be 30cm at least. 3. The exhaust gas outlet sall be firmly placed in the empty space. 4. The exhaust pipe outlet shall not look at the driving direction. (More installation details included in the instruction manual.) Notice: *Due to the manual measurement and different measurement methods, please allow 1-3cm deviation. *Professional installation is recommended *For any needs please contact us.